|
|
Перевод: flange
[существительное]
гребень ; выступ ; борт ; фланец ; край ; кромка ; закраина ; реборда ;
[глагол]
загибать кромку; отбортовывать; фланцевать
Тезаурус:
- A general-purpose rolled insulation blanket can be fitted between timber studding and held in place with wire netting stapled to the timber, or a flanged, paper-faced insulation quilt can be used - the paper flange is opened out and stapled to the timber, thus holding the quilt in place.
- Fitting Range Rover wheels on any SI to SIII Land Rover involves grinding of the drive flange to clear the wheels.
- Smear the flange of the pop-up waste with sealant such as Plumber's Mait, then screw the pop-up body in place, working from the underside.
- Their main distinguishing feature was the solid pressed steel side frame, with a flange round the edge.
- The load forces were taken by the centre hole in the wheel resting on the flange on the end of the axle.
- Swivel housing oil seal, hub oil seal, the gasket between the drive flange and the hub or the felt washer on the end of the half shaft.
- It was also found to give excessive flange wear, and made it necessary to turn the wheels after 20,000 miles in service.
- So the company decided, after a few months of running in service, to adopt a 1 in 100 coning which was reputed to give almost as good riding qualities at high speed, and did not suffer from the disadvantage of excessive flange wear.
- With such tourist pulling potential it was only a matter of time before the line of sections of it would hum again to wheel flange above fishplate and so it proved in 1972 when a narrow gauge scheme was hatched to open 5.5. miles of trackbed between Pant (Merthyr Tydfil) and Torpantau.
- The 3in faceplate and screwchuck, has a central position for use as an ordinary screwchuck with small workpieces, and three holes in the flange for use as a faceplate on larger work.
- With the water supply to the hot water cylinder isolated and the top 500mm of water from the cylinder drained off, fit the Surrey flange into the top of the cylinder, and reconnect the vent and hot water pipe
- The PCR11-;36 fits directly into an industry standard 32mm diameter pipeline or, with a flange fitting, to a vat sight glass.
- The conical stub axles and the cylinder were connected by being bolted to an aluminium flange.
|
 |
|
